No results were found for the filter!
BEC 25A UBEC ESC for 3-18s - Input Voltage: 3-18S LiPo
- Output: 5.2V / 6.0V / 7.4V / 8.4V
- Current cont./peak: 25A / 50A
- 55x40.2x17.6mm, 34g
Part No:
€68.90 *
Ready to ship, Stock Amount: >20 pcs
BEC 10A HV Air UBEC Regler für 3-14s - Input Voltage: 3-14S LiPo
- Output: 6.0V / 7.4V / 8.4V
- Current cont./peak: 10A / 25A
- 55x25x12mm, 35g
Part No:
€36.90 *
Ready to ship, Stock Amount: >20 pcs
BEC 5A V2-Air UBEC Regler für 2-8s - Input Voltage: 2-8S LiPo
- Output: 5.0V / 6.0V / 7.4V
- Current cont./peak: 5A / 15A
- 50x17x10mm, 21g
Part No:
€15.90 *
Ready to ship, Stock Amount: >20 pcs
BEC 10A V2-Car UBEC Regler für 2-6s - Input Voltage: 2-6S LiPo
- Output: 6.0V / 7.4V / 8.4V
- Current cont./peak: 10A / 15A
- 45x20x16.2mm, 34g
Part No:
€27.90 *
Ready to ship, Stock Amount: >20 pcs
Electrical switch with voltage indicator The Powerswitch was designed for replacing the mechanical switch to supply the receiver and servos in nitro cars. The switch is used to switch the receiver supply on and off inside the car. Beside that the Powerswitch informs you about...
Part No:
€24.90 * €26.90 *
Ready to ship, Stock Amount: >20 pcs
Capacitors Module for Xerun ESC with 4 Capacitor Features Super low impedance. Low temperature in working state. Reduces the RF interference to make the RC model more reliable, Improves the burst power when the motor starts to run With its excellent "Ripple Current Endurance", the...
Part No:
€7.90 *
Ready to ship, Stock Amount: >20 pcs
Ready to ship, Stock Amount: >20 pcs
Power Switch 4-12V 10Amp SKYRC introduces the POWER SWITCH, a tiny MCU controlled on/off switch for your radio controlled model. A simple push button operates the switch meaning to eliminate theproblems associated with intermittent contact of an ordinary...
Part No:
€15.90 *
Ready to ship, Stock Amount: >20 pcs
Ready to ship, Stock Amount: >20 pcs
Ready to ship, Stock Amount: >20 pcs
Step Down Voltage Regulator for UBEC With this wire you can drop the voltage by 0,7Volt for your Receiver or Servo. Simply plug the wire in-between the current connection and done. Technical Data: Voltage: minus 0,7V Wire female: JR / Futaba Wire male: JR
Part No:
€5.90 *
Available in 11 days
DC Booster Output 6V 2A for 1s LiPo 1S DC-DC BOOSTER is a DC-DC power booster module which can draw power from the 1S Lipo battery then boosts it to the voltage (6V) suits the receiver & servo and provides the continuous output current up to 3Amp. 1S DC-DC BOOSTER is...
Part No:
€25.90 *
Ready to ship, Stock Amount: 2 pcs
Viewed