No results were found for the filter!
Ready to ship, Stock Amount: >20 pcs
USB Charging Hub PCH-150 for T1000 Charger The PCH-150 PD charging adapter expands the possibilities of the T1000 charger with another handy function. With 150W sheer charging power, it can supply a wide variety of devices with fresh energy at the same time via the 4 connections....
Part No:
€51.90 *
Ready to ship, Stock Amount: 5 pcs
Power Disibutor with Banana Plug The world's smallest multi-port distributor features three DC-output ports which support both, banana connector and alligator clips. Two 5V/2,1A USB ports which support smart phone and other mobile devices. The DC input power lead is...
Part No:
€15.90 *
Ready to ship, Stock Amount: >20 pcs
Mutli Balancer Board for 2-6 cells Universa balancer board for 2-6S Lipo or LiFe and LiIon Batteries. The board works with nearly all currently availablebalancer connctors and fits with most charges without any problems. Features: 2-6S Cell LiPo / LiFe / LiIon (7,4 -...
Part No:
€13.90 *
Ready to ship, Stock Amount: >20 pcs
Temperature Sensor for SkyRC Charger The SKYRC Temperature Sensor enables you to use on any SKYRC chargers equipped with temperature sensing Plug the battery to be charged into the charger. Select the correct battery chemistry type Plug the temperature sensor into the port...
Part No:
€10.90 *
Ready to ship, Stock Amount: 6 pcs
Step Down Voltage Regulator for UBEC With this wire you can drop the voltage by 0,7Volt for your Receiver or Servo. Simply plug the wire in-between the current connection and done. Technical Data: Voltage: minus 0,7V Wire female: JR / Futaba Wire male: JR
Part No:
€5.90 *
Ready to ship, Stock Amount: 11 pcs
DC Booster Output 6V 2A for 1s LiPo 1S DC-DC BOOSTER is a DC-DC power booster module which can draw power from the 1S Lipo battery then boosts it to the voltage (6V) suits the receiver & servo and provides the continuous output current up to 3Amp. 1S DC-DC BOOSTER is...
Part No:
€25.90 *
Ready to ship, Stock Amount: 4 pcs
RPM & Telemetry Signal Coupler Module (SCM) The RPM & Telemetry Signal Coupler Module, or SCM for short, solves the issues like: RPM signal from ESC cannot be correctly recognized by flybarless device GND level of Telemetry signal from ESC doesn't match the GND level of flybarless...
Part No:
€13.90 *
Ready to ship, Stock Amount: 17 pcs
Viewed